ClubIsuzu.org the new home of Clubisuzu.com

Here's why I so busy at the moment
Installing new liners

Installing crank, new bearings..




Oil squirters, two were totally blocked, had to clean them out.

New pistons and rings going into the new liners, new small end bearings (these had to be reamed as they are un unfinished size)

Checking deck height to make sure the head gasket is the right thickness.

I have got all the timing on and lower sump so far, more to come.

what did you use for a timing cover gasket?

It came in the kit, as the kits you buy are for belt and gears. The only thing that hasn't been in the kit so far is the o-ring for the cam shaft seal retainer, which is a 50mm x 2.5mm and diesel pump gasket which I just made. The kit I got from Roodogs on eBay, it had new pistons, liners, bearings, full gasket and seal kits, sealant, and basic setting chart.

The rebuild kit i got was for a gear drive only. I had to get a camshaft seal and T/cover gasket