ClubIsuzu.org the new home of Clubisuzu.com

non egr intake manifold 25.00
bullbar mounts to make custom bumper 25.00
can deliver gold coast or post at buyers expense.
have other parts just msg me.

PM sent.

What are the IC from?

Have you got an intercooler because I'm keen.

FIAD. Fast idle actuator device. Ill keep the catch can on for now until further notice. Also got to test the oil pressure. It reads 3kg at start up. Hangs around 1-2kg during regular driving and sits just above 0kg when idling at full operating temp. This seems to be characteristic of the old motor ...

Well the swap is all done and running well. Swapped over a heap of parts including oil cooler, turbo (rotated but no IC) and manifold, engine mounts, all the external coolant pipes, compressor, oil sensor and accelerator cable bracket and a few other bits and bobs. The pump was a little different ...

If your looking for a cheap pump let me know. I have a spare one. Im on the gold coast but travel to coolangatta most days.

Motor is out of the jack. Couldn't clear the diff so I removed lower sump case and oil pickup then it popped right off. To remove the engine/box/transfer out of donor rodeo I cut the rad support out but haven't lifted it out yet. To put motor back in jack I would like to just slide the gear box back ...

Ok, bought a rodeo 750 km away with about 200,000 on the clock. Just got to get it booked on a truck to bring home. Do you think I could swap the oil cooler over as to avoid having to mod my dump pipe. Are the 2 different 4jb1 oil filters the same size or would i be running under spec?

Don't have a motor yet but all the ones Ive been looking at are from TF rodeos. All the wreckers adds on gumtree state gear driven for 4jb1 97-03.